Sony MVS-8000 - Page 671

Chapter 11 DME Operations
671
DME Special Effect Operations
• When Shape mode is selected
a) Set when Lock is on.
b) Set when Lock is off.
c) Setting for SD 4:3, SD 16:9
d) Setting for HD 4:3, HD 16:9
e) 1 (Circle): Circle
2 (Rectangle): Rectangle
3 (Star): Star
4 (Heart): Heart
To limit the direction in which modulation is applied
By pressing [Plus Only], turning it on, you can limit the direction in which
modulation is applied (the direction in which the image expands) to the plus
direction only.
To set the ripple center point
1 Press [Position], turning it on.
2 Set the following parameters, depending on the selected modulation mode.
• When Shape is selected
a) Setting for SD 4:3, SD 16:9
b) Setting for HD 4:3, HD 16:9
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 Amp R Ripple amplitude 0.00 to 100.00
2 Freq R Ripple frequency 0.00 to 100.00
3
Offset R
a)
Direction in which to offset ripple
phase and amount of movement
–8.000 to +8.000
c)
–32.000 to +32.000
d)
4
Speed R
b)
Ripple direction and speed –100.00 to +100.00
5 Shape Ripple shape
1 to 4
e)
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 Aspect Ripple aspect ratio –100.00 to +100.00
2 Angle Ripple angle –8.000 to +8.000
Knob Parameter Adjustment Setting values
1 H Ripple center point in
horizontal direction
–5.000 to +5.000
a)
–20.000 to +20.000
b)
2 V Ripple center point in vertical
direction
–3.000 to +3.000
a)
–12.000 to +12.000
b)