Chapter 2 Menus and Control Panel
83
Names and Functions of Parts of the Control Panel
a EDIT ENBL (edit enable) button
Press this button, turning it on, to enable
effect editing operations with the keyframe
control block.
When macro editing is carried out, this
button lights red.
b Edit point specification buttons
GO TO TC (Go to timecode): Press this
button, turning it on, to enter a numeric
value from the numeric keypad control
block, and move the edit point to the
specified timecode position.
GO TO KF (Go to keyframe): Press this
button, turning it on, to enter a numeric
value from the numeric keypad control
block, and move the edit point to the
specified keyframe.
During macro editing, pressing this
button moves the edit point to the event
number specified by numeric entry
with the numeric keypad control block.
PREV KF (previous keyframe): When
this button is pressed, the edit point
moves to the keyframe immediately
before the current time (the position
where the effect is currently stopped).
During macro editing, pressing this
button moves the edit point to the event
immediately before the current event.
NEXT KF (next keyframe): When this
button is pressed, the edit point moves
to the keyframe immediately after the
current time.
During macro editing, pressing this
button moves the edit point to the event
immediately after the current event.
0 EFF LOOP button
1 EDIT ENBL button
2 Edit point
specification
buttons
3 Editing buttons
4 Duration setting buttons
5 KF LOOP button
6 PAUSE button
7 Effect execution section
8 Effect execution direction selection
buttons
9 STOP NEXT KF button
qa AUTO INS button
To Next Page
Loading...
