Chapter 13 Keyframe Effects
829
Saving Effects
6
Press the [ENTER] button.
This saves the current effect in the specified register, and turns off the
[STORE] button. The [RCALL] button and [STORE STATS] button both
light.
To undo the saving of an effect
Immediately after saving an effect, hold down the [STORE STATS] button and
press the [UNDO] button to undo the save.
Saving an effect with the Multifunction Flexi Pad control block
1
Press the [EFF] button, turning it on.
This assigns the memory recall section to effect operations.
2
Press the region selection button corresponding to the region for which you
want to save the register, turning it on.
See step 2 of “Recalling a register from the numeric keypad control block”
(page 788).
3
Press the [EDIT ENBL] button.
This assigns the memory recall section to effect editing operations.
4
Press the [STOR] button, turning it on.
5
With the numeric keypad, enter the number of the register in which you
want to save the effect.
To find an empty register, instead of entering a number, press the [.]
(period) button. To search for an empty register common to all currently
selectable regions, press the [.] button again.
To search for an empty register in the 100 range, press [1], [0], [0], [.]
(period) in this order. Similarly, to search for an empty register in the 200
range, press [2], [0], [0], [.] (period), and to search for an empty register in
the 300 range, press [3], [0], [0], [.] (period).
The register number appears in the display. If the number is followed by a
letter ‘e’ or ‘E,’ this indicates the following.
e: The selected register is empty for the regions selected in step 2.
E: The selected register is empty for all selectable regions.
6
Press the [ENTR] button.
This saves the current effect in the specified register, and turns off the
[EDIT ENBL] button.
To Next Page
Loading...
