Chapter 13 Keyframe Effects
800
Specifying the Region and Edit Points
Setting the Edit Points
Keyframe control block
To set the edit points, use any of the following operations in the keyframe
control block.
• To move the edit point to the keyframe immediately after the current time
(the position at which the effect is currently stopped), press the [NEXT KF]
button.
• To move the edit point to the keyframe immediately before the current time,
press the [PREV KF] button.
• To move the edit point to a keyframe specified by number, press the [GO TO
KF] button, then enter the keyframe number with the numeric keypad in the
numeric keypad control block or Multifunction Flexi Pad control block, and
press the [ENTER] button to confirm.
• To move the edit point to a specified timecode, press the [GO TO TC] button,
then enter the timecode value with the numeric keypad in the numeric
keypad control block, or Multifunction Flexi Pad control block and press the
[ENTER] button to confirm.
EDIT ENBL button
Buttons used for editing
CONST DUR button
To Next Page
Loading...
