Chapter 4 Keys
247
Key Setting Operations Using Menus
Blink Function
With the blink function, you can obtain the following effects.
Key blink: The key is alternately inserted and deleted at regular intervals. You
can set the period of blinking, and the proportion of each cycle for which
the key is inserted.
Edge blink: The key fill and key edge fill signals are interchanged at regular
intervals. You can set the period of blinking, and the proportion of each
cycle for which the original state holds.
The blink settings are in the Transition menu for each key.
Using the blink function
For example, to make the required settings for key 1 on the M/E-1 bank, use
the following procedure.
1
In the M/E-1 >Key1 menu, select HF6 ‘Transition.’
The Transition menu appears.
2
In the <Blink> group, select [Key Blink] or [Edge Blink] to set it on.
3
Set the blink parameters.
• When key blink is selected
• When edge blink is selected
Video Processing
You can adjust the luminance and hue of the selected key fill signal.
For example, to apply video processing to the signal selected on the M/E-1
bank key 1 fill bus, use the following procedure.
Knob Parameter Adjustment Setting values
1 Blink Rate Length of blink cycle 1 to 100
2 Duty Proportion of cycle for which key
inserted
0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Blink Rate Length of blink cycle 1 to 100
2 Duty Proportion of cycle for which
original state holds
0.00 to 100.00
To Next Page
Loading...
