Chapter 16 Macros
920
Macro Operations in the Standard Type Flexi Pad Control Block
Macro Operations in the Standard Type
Flexi Pad Control Block
This section describes how to carry out macro operations in a standard type
Flexi Pad control block.
For an overview of macros, see “Macros” (page 902).
Using the <Flexi Pad Edit Mode> group buttons in the Engineering Setup
>Panel >Operation >Macro menu, you can set the macro execution mode to
“Pause Only” or “Full Editing” (see “Setting the Macro Execution Mode” in
Chapter 19 (Volume 3)).
The display of the standard type Flexi Pad control block changes as follows,
depending on the selected mode of macro execution.
When entering macro editing mode with “Pause Only” selected
Numeric display
UNDO button
Bank selection buttons
Memory recall section
MCRO button
STORE STATS button
To Next Page
Loading...
