Sony MVS -8000X - Enabling or Disabling AUX Bus Control

Chapter 20 Switcher Setup (Switcher)
1209
Interfacing With External Devices (Device Interface Menu)
6 Using any of the following methods, select the action to be set.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
a) • Action list when the trigger type is other than “Status”
(In M/E-x, the x is the M/E bank number (1 to 4); in DSKx the x is the DSK number
(1 to 8); in Keyx the x is the key number (1 to 8)).
When Source is M/E-x: Cut, Auto Trans, Keyx Cut, Keyx Auto Trans, Keyx SS ?
Recall, Effect ? Recall, Effect ? Recall & Run, KF Run, KF Stop, KF Rewind, No
Action
When Source is P/P: Cut, Auto Trans, DSKx Cut, DSKx Auto Trans, FTB Cut, FTB
Auto Trans, DSKx SS ? Recall, Effect ? Recall, Effect ? Recall & Run, KF Run,
KF Stop, KF Rewind, No Action
When Source is Common: No Action
• Action list when the trigger type is “Status”
(In M/E-x, the x is the M/E bank number (1 to 4); in DSKx the x is the DSK number
(1 to 8); in Keyx the x is the key number (1 to 8)).
When Source is M/E-x: Keyx On, No Action
When Source is P/P: DSKx On, No Action
When Source is Common: Error Make, Error Break, No Action
b) When knob 2 selection is “Key Snapshot”
c) When knob 2 selection is “Snapshot” or “Effect”
7 Press [Action Set] to confirm the action selection.
The selected setting appears in the status area.
Test firing the trigger
To test fire the trigger, press [Test Fire].
This outputs a trigger from the selected output port. This is not output when the
trigger type is “Status.”
Enabling or Disabling AUX Bus Control
1 In the Switcher >Device Interface menu, press [Aux Control].
The Aux Control menu appears.
2 Select the 9-pin port for the setting, from the <Control> group.
Remote1: Make the settings for the REMOTE1 port.
Knob Parameter Adjustment Setting values
2 Action Action selection
1 and upwards
a)
5 Reg No Register number
1 to 4
b)
1 to 99
c)