Chapter 10 Special Functions
486
Multi Program 2
4
Create the sub video.
The basic method of operation is the same as for the main video, except
that the utility 2 bus signal is assigned to background A, and the utility 3
bus signal is assigned to background B.
For sub, only keys 2 to 8 can be used, and for wipes, standard wipe patterns
only. There are also other differences in operation from standard mode.
For details, see “Differences Between Multi Program 2 Mode and
Standard Mode” (page 491) and “Restrictions on Using Multi Program 2
Mode” (page 492).
5
Press the [MAIN] and [SUB] buttons simultaneously, turning them on.
If both buttons are lit, the control panel shows the status of main.
6
Carry out the transition.
Both main and sub video images are switched.
Optional Operations
Making cross-point settings
Cross-point assign tables can be set not only for main output but also for sub
output.
You can set cross-point assign tables for the following banks.
M/E-1 SUB to M/E-4 SUB
P/P SUB
The table actually used is that for which the control panel delegation button is
lit.
For details, see “Cross-Point Settings (Xpt Assign Menu)” in Chapter 19
(Volume 3).
Enabling DME wipe operations for sub
By factory default, DME wipe operations are inhibited for sub background. To
enable them, in the Engineering Setup >Switcher >Config menu, set [DME
Wipe Sub Enable] to On.
This enables DME wipe operations for sub background.
This setting applies to the whole control panel (all M/E banks and PGM/PST
bank).
To Next Page
Loading...
