Chapter 2 Menus and Control Panel
81
Names and Functions of Parts of the Control Panel
j EFF LOOP (effect loop) button
When the effect reaches the last keyframe
with this button on, it returns to the first
keyframe and repeats.
k AUTO INS (auto insert) button
When editing a macro, press this button,
turning it on, to enable the auto insert
function, so that every control panel
operation you carry out is added to the
macro as an event.
Numeric Keypad Control Block
The numeric keypad control block is used
for region selection, for saving and
recalling snapshots, effects and shotboxes,
for entering numeric values for trackball
operation and keyframe operation, and for
transition rate entry.
a Mode selection buttons
EFF (effect): Press to save or recall an
effect.
SNAPSHOT: Press to save or recall a
snapshot.
SHOTBOX: Press to save or recall a
shotbox.
MCRO (macro): Press to save, recall or
edit a macro.
TRANS RATE (transition rate): Press to
set the transition rate.
Hold down this button, and press one of
the key delegation buttons [KEY1] to
[KEY8] in the transition control block
1 Mode selection buttons
5 Display
2 Region selection buttons
3 Function selection buttons
4 Numeric keypad
To Next Page
Loading...
