Sony MVS -8000X - Assigning the Utility;Shotbox Mode Switching Function

Chapter 19 Control Panel Setup (Panel)
1096
Overall Control Panel Settings (Config Menu)
Assigning the Utility/Shotbox Mode Switching Function
You can first assign functions to the key 2 row cross-point buttons, and then
use them in the same way as the buttons in the utility/shotbox control block.
To switch this mode on and off, it is necessary to assign this function to the
cross-point control block [PRE MCRO] button.
For details of how to assign a function to this button, see “Assigning a
Function to the Key 2 Row Cross-Point Buttons” (page 1141).
1 In the Panel >Config menu, press [Link/Program Button].
The Link/Program Button menu appears.
2 Press [Xpt Module].
The Xpt Module menu appears.
3 Using any of the following methods, select the bank.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
4 Select [Utility/Shotbox] in the <PRE MCRO/POST MCRO> group.
This assigns the utility/shotbox mode to the [PRE MCRO] button, and
disables the [POST MCRO] button.
Assigning the Function to Disable Cross-Point Button
Operations to a Button
1 In the Panel >Config menu, press [Link/Program Button].
The Link/Program Button menu appears.
2 Press [Xpt Module].
The Xpt Module menu appears.
3 Using any of the following methods, select the bank.
• Press directly on the list in the status area.
Knob Parameter Adjustment Setting values
1 Bank Bank selection 1 to 5