Chapter 19 Control Panel Setup (Panel)
1145
Interfacing With External Devices (Device Interface Menu)
• If “System Format” is selected for “Action” when the format converter is
used on the switcher, you can set the conversion formats of the format
converter for “FC Input 1-8”, “FC Input 9-16”, “FC Output 1-2” and “FC
Output 3-4”.
Carrying out level settings
To set the low level and high level, first set the trigger type to “Level,” then use
the following procedure.
1
In the Panel >Device Interface menu, select the action to be set, and press
[H/L Set].
The H/L Set menu appears.
2
Using any of the following methods, select the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
3
To apply the selection made in step 2 when the input is the GPI high level,
press [H Set]. To apply the selection made in step 2 when the input is low,
press [L Set].
This confirms the setting, which appears in the status area.
Making Control Panel GPI Output Settings
1
In the Panel >Device Interface menu, press [GPI Output].
The GPI Output menu appears.
2
Using any of the following methods, select the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter Adjustment Setting values
1 No Signal format/screen
aspect ratio selection
1 and upwards
Knob Parameter Adjustment Setting values
1 Port Port selection 1 to 8
To Next Page
Loading...
