Chapter 19 Control Panel Setup (Panel)
1095
Overall Control Panel Settings (Config Menu)
To switch the [UNDO] button on a simple type Flexi Pad control block to a
[MCRO] button for macro operation, use the following procedure.
1
In the Panel >Config >Link/Program Button menu, press [Flexi Pad
Module].
The Flexi Pad Module menu appears.
2
Select the assignment of the [UNDO] button in the simple type Flexi Pad
control block from the <UNDO Button Assign> group.
UNDO: use as an [UNDO] button.
MACRO: use as a [MCRO] button.
Assigning the Dual Background Bus Mode Switching
Function
The dual background bus mode is a mode in which the background A row
shifted signal can be selected with the key 1 row, and the background B row
shifted signal can be selected with the key 2 row. To switch this mode on and
off, it is necessary to assign this function to the cross-point control block [PRE
MCRO] button.
For details of the dual background bus, see “Signal Selection” in Chapter 3
(Volume 1).
1
In the Panel >Config menu, press [Link/Program Button].
The Link/Program Button menu appears.
2
Press [Xpt Module].
The Xpt Module menu appears.
3
Using any of the following methods, select the bank.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
4
In the <PRE MCRO/POST MCRO> group, select [Dual Bkgd Bus].
This assigns the dual background mode to the [PRE MCRO] button, and
disables the [POST MCRO] button.
Knob Parameter Adjustment Setting values
1 Bank Bank selection 1 to 5
To Next Page
Loading...
