Sony MVS -8000X - Preparations

Chapter 9 Color Corrector
454
Preparations
Preparations
The color corrector enables video signal color correction (black balance/white
balance adjustment, gamma correction, knee correction, etc.).
Notes
To use the color corrector, the BZS-8420X Color Corrector Software. To use
the software, you are required to input an install key.
For the method of inputting an install key, see “Installation and Device Setup
(Install/Unit Config Menu)” in Chapter 18 (Volume 3).
Restrictions on color corrector and M/E combination
Example of restriction 2: When M/E-1 is selected on the M/E-2 background
A bus (or background B bus, key bus, or utility 1 or 2 bus), then M/E-2
cannot be selected on the M/E-3 key bus or the utility 1 bus.
Assigning the color corrector input buses to AUX delegation
buttons
There are two inputs for capturing material to the color corrector: the CCR1
bus and the CCR2 bus.
For details of the input assignment operation, see “Auxiliary Bus Control
Block Settings (Aux Assign Menu)” in Chapter 19 (Volume 3).
Signal
format
When the color corrector output is selected When the color corrector output
is not selected
3M/E system 4M/E system/5M/E system 4M/E system/5M/E system
Other
than
720P
– Re-entry signal selection on a key
bus or the utility 1 bus cannot be
performed over a cascade of two or
more M/E blocks. (Restriction 2)
–
720P Re-entry signal
selection on a
key bus or the
utility 1 bus
cannot be
performed over a
cascade of two
or more M/E
blocks.
(Restriction 2)
Re-entry signal selection on a key
bus or the utility 1 bus cannot be
performed. (Restriction 1)
Re-entry signal selection on a key
bus or the utility 1 bus cannot be
performed over a cascade of two or
more M/E blocks. (Restriction 2)