Chapter 19 Control Panel Setup (Panel)
1130
Setting Button Assignments (Prefs/Utility Menu)
Setting Button Assignments (Prefs/Utility
Menu)
Assign the [PREFS 1] to [PREFS 16] buttons in the menu control block, the
utility/shotbox control block buttons, and the cross-Point control block.
This assigns recalling frequently used menus (menu shortcuts), enabling/
disabling functions (recalling utility commands) and recalling shotbox
registers or macro registers.
• User Preference: Make the settings for the user preference buttons in the
menu control block.
• Utility Module Assign: Make the utility/shotbox control block settings.
• KEY 2/4 Bus Button Assign: Make the settings for the key 2 row buttons in
the cross-point control block.
To display the Prefs/Utility menu
In the Engineering Setup menu, select VF2 ‘Panel’ and HF4 ‘Prefs/Utility.’
The status area shows the settings of the user preference buttons.
Assigning Functions to User Preference Buttons
1
In the Panel >Prefs/Utility menu, using any of the following methods,
select the button to be assigned.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
2
In the <Action> group, select the function to be assigned.
Menu Shortcut: Assign a frequently used menu to be recalled (menu
shortcut).
Utility Command: Assign a function enable/disable or similar operation
(utility command).
Macro Recall: Assign a macro register recall.
Shotbox Recall: Assign a shotbox register recall.
3
Depending on the selection in step 2, make the following settings.
Knob Parameter Adjustment Setting values
1 No User preference button selection 1 to 16
To Next Page
Loading...
