Sony MVS -8000X - Key Snapshot Operations Using a Simple Transition Module

Chapter 4 Keys
287
Key Snapshots
To recall a key snapshot
For example, to recall a key snapshot for M/E1 key 1 saved in register 1, with
the M/E1 region and key 1 selected, proceed as follows.
1 Press the [KEY SS] button.
2 According to the information you want to recall, set the following buttons
On/Off.
[MOD ENBL] button: Recall the key adjustment values and key modifier
settings.
[TRNS ENBL] button: Recall independent key transition settings.
If both are Off, then key memory is enabled, and just the saved key fill
and key source signal selections are recalled.
3 Press button [1] for the register you want to recall.
The [1] button lights yellow, and the key snapshot is recalled.
To cancel the recall operation, press the [UNDO] button.
To delete a key snapshot
For example, to delete a key snapshot for M/E1 key 1 saved in register 1, with
the M/E1 and key 1 region selected, proceed as follows.
1 Press the [KEY SS] button.
2 Holding down the [DEL] button, press the button [1] for the register in
which is saved the key snapshot you want to delete.
To carry out an auto transition execution during key snapshot
operation
Press the [AUTO TRNS] button.
Instant key insertion/removal
Press the [KEY ON] button.
To remove the key, while the key is inserted press the [KEY ON] button.
Key Snapshot Operations Using a Simple Transition
Module
When using a simple transition module, the key snapshots hold the settings for
key 3 and key 4. However, each key control block can be assigned to any key
in setup (see “Overall Control Panel Settings (Config Menu)” in Chapter 19
(Volume 3)).