Sony MVS -8000X - Setting DME and Switcher Interfaces

Chapter 20 Switcher Setup (Switcher)
1210
Interfacing With External Devices (Device Interface Menu)
Remote2: Make the settings for the REMOTE2 port.
Remote3: Make the settings for the REMOTE3 port.
Remote4: Make the settings for the REMOTE4 port.
3 Using any of the following methods, select the AUX bus.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
a) 0: EDIT PVW
1 to 48: AUX1 to AUX48
4 Select whether to enable or disable AUX bus control from the <Control
Mode> group.
Enable: enable control of the port selected in step 2.
Disable: disable control of the port selected in step 2.
Manual: make whether control of the port selected in step 2 is possible or
not depend on the setting in the Misc menu.
5 Repeat steps 2 to 4 as required to make the settings for other ports.
Setting DME and Switcher Interfaces
Select the signals (AUX bus output signals) input to the DME as follows.
Notes
When using the MVE-8000A, it is not necessary to make this setting.
1 Press [DME SDI Interface] in the Switcher >Device interface menu.
The DME SDI Interface menu appears.
2 Using any of the following methods, select the DME channel to which
operations apply.
• Press directly on the list on the left of the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter Adjustment Setting values
1 No AUX bus selection
0 to 48
a)
Knob Parameter Adjustment Setting values
1 DME Ch No DME channel selection 1 to 24