Sony MVS -8000X - Clearing a Source Address Setting

Chapter 23 Setup Relating to Router Interface and Tally (Router/Tally)
1262
Serial Tally Settings (Serial Tally Menu)
2 In the <Serial Tally Port> group, select the port to which the setting
applies.
3 Using any of the following methods, select the port bit number.
• Press directly on the list on the left of the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
4 Turn the knob to select the source address.
5 Press [Source Address Set].
This confirms the setting.
Clearing a Source Address Setting
To clear a source address setting for a particular bit
In the Router/Tally >Serial Tally >Source Assign menu, select the serial tally
port and bit number (see steps 2 and 3 in the previous item), then press [Clear].
This clears the source address setting for the selected bit.
To clear all source address settings
In the Router/Tally >Serial Tally >Source Assign menu, select the serial tally
port, then press [All Clear].
A confirmation message appears.
• If you select “Yes,” this clears all source address settings for the selected
serial tally port.
• If you select “No,” the clear operation is canceled.
Knob Parameter Adjustment Setting values
1 Bit No Bit selection 1 and upwards
Knob Parameter Adjustment Setting values
2 Source Addr Source address selection 1 to 1024