Chapter 5 Wipes
320
Wipe Settings for Independent Key Transitions
Notes
In an independent key transition, you can only use the standard wipe patterns
(pattern numbers 1 to 24).
To select a wipe pattern for independent key1 on the M/E-1 bank, use the
following procedure.
1
In the Key1 Wipe Adjust menu, select [Pattern Select].
The Pattern Select menu appears.
2
Press the button for the desired pattern.
Setting Independent Key Transition Wipe Modifiers
Available modifiers
You can use the following modifiers with an independent key transition wipe.
Note that the available modifiers may depend on the pattern you are using.
• Direction
• Edge
• Positioner
• Rotation
• Aspect ratio
• Pattern replication
Setting the wipe direction (Direction)
In the <Direction> group of the Key1 Wipe Adjust menu, make any of the
following selections.
Normal: regular direction
Normal/Reverse: alternate between regular and reverse for each transition
Reverse: reverse direction to normal
Softening the wipe pattern edge (Soft edge)
1
Press [Soft] in the Key1 Wipe Adjust menu, turning it on.
2
Set the following parameter.
Knob Parameter Adjustment Setting values
1 Soft Edge softness 0.00 to 100.00
To Next Page
Loading...
