Chapter 4 Keys
243
Key Setting Operations Using Menus
• When utility 1 bus is selected
5
To invert the black and white sense of the mask source, press the [Mask
Invert] button, turning it on.
Applying a DME Effect to a Key
Notes
• On keys 1 to 4 of one M/E, a maximum of two DME effects (including DME
wipes) can be used simultaneously. However, when using a DME wipe
pattern for the background, the restriction depends on the execution mode as
follows.
One-channel mode: DME can only be used in one place on keys 1 to 4.
Two-channel mode or three-channel mode: DME cannot be used for keys 1
to 4.
• When the system signal format is 1080P, and the DME input/output signal
format is set to dual link mode, the following restrictions apply.
– On keys 1 to 4 of one M/E, a maximum of one DME effect (including
DME wipes) can be used simultaneously.
– When a DME wipe pattern is selected for the background, DME cannot be
used for keys 1 to 4.
• On keys 5 to 8 of one M/E, a maximum of two DME effects (including DME
wipes) can be used simultaneously. However, for keys 5 to 8 of the M/E4
block, DME effects cannot be used.
For details, see “Interfacing With External Devices (Device Interface Menu)”
in Chapter 19 (Volume 3).
For keys 5 to 8 on the M/E4 bank, DME effects cannot be applied.
Assigning a DME to a key
1
In the M/E-1 >Key1 menu, select HF5 ‘Processed Key.’
The Processed Key menu appears.
2 Soft Edge softness 0.00 to 100.00
Knob Parameter Adjustment Setting values
Knob Parameter Adjustment Setting values
1 Clip Reference level for creating mask
signal
+109.59 to –7.31
2 Gain Gain –100.00 to +100.00
To Next Page
Loading...
