Chapter 2 Menus and Control Panel
100
Names and Functions of Parts of the Control Panel
Downstream Key Control Block
a Key delegation buttons
Press one of the [DSK1] to [DSK4] buttons
to delegate this control block to the
corresponding keyer.
Using the Setup menu, it is possible to
assign these to DSK5 to DSK8 or M/E keys
1 to 8.
While these buttons are held down, you can
select a key source with the cross-point
buttons for the key bus.
Pressing one of these buttons twice in rapid
succession changes its state so that you can
make cross-point selections on the
corresponding key bus.
b Independent key transition type
selection buttons
Press one of these buttons, turning it on, to
select the downstream key transition type.
MIX: Carry out a dissolve with the key
selected with the key delegation
buttons.
WIPE: Carry out a wipe with the key
selected with the key delegation
buttons.
DME: This switches the key selected with
the key delegation buttons, using a
DME wipe.
CUT: Instantaneously insert or delete the
key selected with the key delegation
buttons.
1 Key delegation buttons
5 Key source name display/key snapshot
buttons
4 Key snapshot setting
buttons
3 Independent key transition execution section
2 Independent key transition type
selection buttons
To Next Page
Loading...
