Chapter 23 Setup Relating to Router Interface and Tally (Router/Tally)
1257
Tally Copy Settings (Tally Copy Menu)
Tally Copy Settings (Tally Copy Menu)
You can copy the tally information pertaining to a particular source to a
different source.
For settings relating to the tally copy function, use the Router/Tally >Tally
Copy menu. The settings are common to the parallel and serial tallies.
To display the Tally Copy menu
In the Engineering Setup menu, select VF6 ‘Router/Tally’ and HF5 ‘Tally
Copy.’
The status area shows the tally copy status.
Making New Tally Copy Settings
1
In the Router/Tally >Tally Copy menu, select [New].
The New menu appears.
2
Turn the knob to select the copy-from source.
When setting more than one tally copy, you can specify the copy-from
source start and end addresses.
3
Specify the copy-to source address.
4
Press [Execute].
This makes the tally copy setting according to the specifications in steps 2
and 3.
Knob Parameter Adjustment Setting values
1 Copy From (From) Copy-from source start address 1 to 1024
2 Copy From (To) Copy-from source end address 1 to 1024
Knob Parameter Adjustment Setting values
3 Copy To (From) Copy-to source (start) address 1 to 1024
4 Copy To (To) Copy-to source (end) address 1 to 1024
To Next Page
Loading...
