Chapter 19 Control Panel Setup (Panel)
1122
Cross-Point Settings (Xpt Assign Menu)
Notes
Since destination names cannot be selected freely, fixed names are used.
Making Settings for Audio Mixer
Enabling the function to link the audio mixer
Notes
For audio mixer operations in this system, it is necessary to set Mixer ESAM-
II for the DCU 9-pin serial port.
For details, see “Serial Port Settings (Serial Port Assign Menu)” (page 1234).
1
In the Panel >Xpt Assign menu, using any of the following methods, select
the M/E bank or bus.
• Press directly on the list on the left of the status area.
• Press the arrow keys in the list on the left, to scroll the reverse video
cursor.
• Turn the knob.
2
Press [Audio Follow].
“Enable” appears in the “Audio Follow” column.
Setting the audio mixer cross-points
To assign an audio mixer cross-point to a switcher cross-point pair (video/key),
carry out the following procedure.
1
In the Panel >Xpt Assign menu, press [Mixer Xpt Assign].
The Mixer Xpt Assign menu appears.
2
In the list on the left, select the number for the setting.
3
In the list on the right, select the audio mixer cross-point (machine
number).
4
Press [Set].
The audio mixer number appears in the “Mixer Xpt” column.
To Next Page
Loading...
