Sony MVS -8000X - Using the Auxiliary Bus Control Block for Router Control

Chapter 19 Control Panel Setup (Panel)
1125
Auxiliary Bus Control Block Settings (Aux Assign Menu)
a) The setting can be from 1 to 62. The valid settings, however, depend on the number of
buttons and the delegation button shift mode.
b) The buses that can be assigned are as follows.
(In M/E-x, the x is the M/E bank number (1 to 4); in DSKx the x is the DSK number (1
to 8); in Keyx the x is the key number (1 to 8).)
Edit Preview, Aux1 to Aux48, Frame Memory Source1 and Frame Memory Source2,
DME1V to DME8V, DME1K to DME8K, P/P Utility1 and P/P Utility2, M/E-x Utility1
to M/E-x Utility2, DSKx Fill/Source, M/E-x Keyx Fill/Source, PP EXT DME, M/Ex
EXT DME, DME Utility1 and DME Utility2, CCR1 and CCR2
• For a button for which you want to disable operation, press [Inhibit].
2 Press [Set] to confirm the selection.
To set the AUX delegation button shift operation
To set the operation mode of the rightmost button in the row of AUX
delegation buttons, select one of the following in the <Shift Mode> group of
the Panel >Aux Assign menu.
Hold: Acts as a shift button, and the shifted version of the AUX delegation
buttons is enabled while the button is held down.
Lock: Acts as a shift button, and pressing the button toggles between the
shifted version and the unshifted version of the AUX delegation buttons.
Off: Acts as an AUX delegation button. In a 16-button system it acts as button
number 16, in a 24-button system as button number 24, and in a 32-button
system as button number 32.
Using the Auxiliary Bus Control Block for Router
Control
To make router control settings, display the Setup >Panel >Aux Assign >RTR
Mode Setting menu.
Knob Parameter Adjustment Setting values
1 Deleg No Selection of AUX delegation
button
1 to 128
a)
2 Bus No Selection of bus to be assigned
1 to 166
b)
Number of buttons Shift mode Valid settings
16 OFF 1 to 16
ON 1 to 30
24 OFF 1 to 24
ON 1 to 46
32 OFF 1 to 32
ON 1 to 62