Chapter 15 Utility/Shotbox
881
Utility Execution
Executing a Utility in the Utility/Shotbox Control Block
Utility/shotbox control block
By default, the memory recall buttons in the utility/shotbox control block are
assigned to shotbox registers 1 to 96, in banks 1 to 4 (see page 896), but in the
setup menu, you can assign these to any 96 actions.
To execute an assigned action
When the action is to execute a shotbox register, follow the procedure in
“Shotbox Execution in the Utility/Shotbox Control Block” (page 896).
1
Press one of the bank selection buttons [BANK1] to [BANK4] to select a
bank.
• The bank selection button you pressed lights amber.
• For the selected bank, the memory recall buttons show the button
numbers and corresponding button states. If a button has been given a
name in the setup menu, this name appears.
Not lighted: buttons with nothing saved
Lit orange: buttons saving a utility command or menu shortcut
2
Press the memory recall button for which the action you want to execute
has been registered.
Bank selection buttons
Memory recall buttons
To Next Page
Loading...
