Chapter 21 DME Setup (DME)
1216
Settings Relating to Signal Outputs (Output Menu)
Settings Relating to Signal Outputs (Output
Menu)
To make settings relating to DME output signals, display the DME >Output
menu.
You can select the signals output from the four monitor output connectors.
To display the Output menu
In the Engineering Setup menu, select VF4 ‘DME’ and HF3 ‘Output.’
Setting the Monitor Output
To set the signals output from the four monitor output connectors, use the
following procedure.
1
In the DME >Output menu, press [Monitor Output].
The Monitor Output menu appears.
2
In the <Select> group, select the DME to which the setting applies.
DME1: Select DME1.
DME2: Select DME2.
When the signal format is 1080P, you can also select DME3 or DME4
similarly.
3
In the list on the left of the status area, press directly on the monitor output
for which you want to make setting.
Notes
When the signal format is 1080P, you cannot select MONI OUT#2 and
MONI OUT#4.
4
In the list on the right of the status area, press directly on the signal you
want to output.
5
Press [Set].
The selection is reflected in the monitor output.
To Next Page
Loading...
