Chapter 18 System Setup (System)
1058
Selecting the State After Powering On (Start Up Menu)
Saving User-Defined Settings
Saving the Setup settings
1
After selecting the devices to which the settings apply to, in the System
>Start Up menu, press [Setup Define].
A confirmation message appears.
2
Press [Yes].
This saves the setup settings for the selected devices in non-volatile
memory within the respective devices.
For details about the settings which will be saved, see“Data Saved by
[Setup Define] and [Initial Status Define]” (page 1272).
Saving the Initial Status settings
1
After selecting the devices to which the settings apply to, in the System
>Start Up menu, press [Init Status Define].
A confirmation message appears.
2
Press [Yes].
This saves the initial status settings other than the “setup” settings for the
selected devices in non-volatile memory within the respective devices.
For details about the settings which will be saved, see “Data Saved by
[Setup Define] and [Initial Status Define]” (page 1272).
Setting Automatic Loading of Register Data at Power
On (Autoload Function)
To have specified data read in at power on, in the System >Start Up menu,
press [Power On File Load], turning it on.
This enables the autoload function.
When the autoload function is enabled, a directory “PWON_LD” appears in
the corresponding File menu.
About saving data which can be loaded by the autoload function, see “Saving
Files Recalled by Autoload” in Chapter 17 (Volume 2).
To Next Page
Loading...
