Chapter 19 Control Panel Setup (Panel)
1094
Overall Control Panel Settings (Config Menu)
1
In the Panel >Config menu, press [Link/Program Button].
The Link/Program Button menu appears.
2
Press [Transition Module1].
The Transition Module1 menu appears.
3
Select the bank of the transition control block you want to set in the <Bank
Select> group.
The current assignment of the buttons appears at the left.
4
Press the transition type selection button for which you want to change the
assignment.
The button you pressed appears in reverse video.
5
Using any of the following methods, select the function to be assigned,
from the list on the right.
• Press directly on the list.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
6
Press [Set].
The texts on the button illustrations change to reflect the selection.
To cancel the assignment
Press [Clear].
To make the assignment the default
Press [Default].
Setting the Assignment of Macro Operation Buttons
Notes
This setting applies to all simple type Flexi Pad control blocks on the control
panel.
Knob Parameter Adjustment Setting values
1Button
Assign
Selection of function 1 and upwards
To Next Page
Loading...
