Chapter 7 Frame Memory
422
External Hard Disk Drive Access
3
In the <Backup> group, do either of the following.
• To replace the existing data, press [Replace].
• To save in addition to the existing data, press [Append].
A popup window for confirming file saving appears.
Notes
When you execute [Replace], all of the saved files in the logical drive is
erased immediately before the saving operations.
4
Press [Yes].
This starts the file saving operation. If there is no directory, a directory is
automatically created, and the files are saved within it. A progress bar and
numerical indication appear to show the progress of the operation.
When the operation is completed, a popup window reading “Completed.”
appears.
5
Press [OK].
To rename a directory
Select a directory in the list, and in the button area press [Rename].
In the keyboard window that appears, enter the new directory name, and press
[Enter]. The name of a directory is limited to eight characters.
Notes
The following names cannot be used:
CON, PRN, AUX, CLOCK$, NUL, COM0, COM1, COM2, COM3,
COM4, COM5, COM6, COM7, COM8, COM9
LPT0, LPT1, LPT2, LPT3, LPT4, LPT5, LPT6, LPT7, LPT8, LPT9
Recalling Files
You can recall all of the saved files on the hard disk drive into frame memory.
1
Carry out steps 1 and 2 of the procedure “Saving Files” (page 421).
Notes
It is not possible to select a partition (FMHDD1 to FMHDD15) of a hard
disk in which no file is saved.
2
In the <Restore> group, do either of the following.
To Next Page
Loading...
