Chapter 20 Switcher Setup (Switcher)
1170
Settings for Switcher Configuration (Config Menu)
a) 1 to 6: M/E1 OUT1 to 6
7 to 12: M/E2 OUT1 to 6
13 to 18: M/E3 OUT1 to
19 to 24: M/E4 OUT1 to 66
6
In the <Key 1> to <Key 8> groups, select the corresponding key status
from the following.
Link: Follow the key on/off setting.
On: Key is always on.
Off: Key is always off.
Setting User Regions
Notes
If you change the user region settings, the previously stored snapshot data and
keyframe effect data can no longer be used.
1
In the Switcher >Config menu, press [User1-8 Config].
The User1-8 Config menu appears. The status area shows the region names
and assigned user region numbers.
2
Using any of the following methods, select the region you want to set.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
3
In the <User Region Assign> group, select the user region you want to
assign. If you do not want to assign a user region, select [No Assign].
4
Repeat steps 2 and 3 as required to make the settings for other regions.
5
To confirm the setting, press [Execute]. To cancel the setting and return to
the original state, press [Clear] before pressing [Execute].
When you press [Execute], a confirmation message appears.
6
Press [Yes].
This assigns a region to a user region.
Knob Parameter Adjustment Setting values
1 Region Region selection 1 and upwards
To Next Page
Loading...
