Chapter 22 DCU Setup (DCU)
1224
Settings Relating to Parallel Inputs (Input Config Menu)
4
To confirm the assignment in step 3, press [GPI Input Set].
This assigns the GPI input, and this is reflected in the status area.
Releasing the Assignment of a GPI Input Port
1
In the DCU >Input Config menu, select what the setting applies to (DCU1
or DCU2) from the <DCU Select> group.
2
In the <Parallel Input Assign> group, if [GPI Input] is on, press it to turn
it off.
3
Turn the knobs to adjust the following parameters.
4
In the <Parallel Input Assign> group, press [No Assign].
Knob Parameter Adjustment Setting values
1 From No First port number 1 to To No
2 To No Last port number From No to 102
To Next Page
Loading...
