Chapter 19 Control Panel Setup (Panel)
1086
Overall Control Panel Settings (Config Menu)
All: Key selected with one of the key delegation buttons
Key1 to Key4: Key assigned to key delegation buttons 1 to 4 ([DSK1] to
[DSK4] buttons)
Linking Switcher Bus and Router Destination
To provide links between the switcher bus and router destination, make the
following settings as required.
Matrix selection: Select the target of link setting from the eight matrices (1 to
8).
Matrix position definition: Set the start address and level for the source and
destination on the S-Bus.
Link table setting: Link a switcher cross-point button and matrix source.
Link bus setting: Link a switcher bus address and router destination.
Selecting a matrix number
1
In the Panel >Config menu, press [Link/Program Button].
The Link/Program Button menu appears.
2
In the <Link> group, press [External Bus Link].
The External Bus Link menu appears.
The status area shows the current link status.
3
Turn the knobs to select the matrix.
In the status area, the color of the selected part changes.
4
Press [Link Matrix Set].
This confirms the matrix selection and the selected part in the status area
returns to the previous color.
To delete a link
With the link selected, press [Clear].
Knob Parameter Adjustment Setting values
1 Link No Link number 1 to 64
2 Link Matrix Matrix number 1 to 8
To Next Page
Loading...
