Chapter 3 Signal Selection and Transitions
152
Signal Selection
For details of how to make the assignment, see Chapter 19 “Control Panel
Setup (Panel)” (Volume 3).
Selecting the AUX bus
1
Switch the operation mode with the [AUX CTRL] button.
2
In the key 1 row, select the AUX bus for the operation.
3
In the key 2 row, select the desired signal.
Signal Assignment and Selection
Assigning signals to buttons
Each of the 32 cross-point buttons and reentry buttons has a corresponding
button number, to which you assign a signal.
In addition to the signals input to the PRIMARY INPUTS 1 to 144 connectors,
the PREMIUM INPUTS 1 to 20 connectors, or the FC INPUTS 1 to 16
connectors on the rear panel of the switcher, you can also select signals
generated within the switcher.
Each button has assigned to it a video signal and a key signal, forming a pair.
You can set these video and key combinations in a Setup menu.
For details of Setup menu operations, see “Cross-Point Settings (Xpt Assign
Menu)” in Chapter 19 (Volume 3).
Cross-point button control block button numbers
(first button numbers)
(second button numbers)
Shift button
Shift button
To Next Page
Loading...
