Sony MVS -8000X - Restrictions on Using Multi Program 2 Mode

Chapter 10 Special Functions
492
Multi Program 2
a) Keys 2 to 8 are common to main and sub.
Notes
• Allow a transition to complete before carrying out main and sub delegation
switching.
• The sub background A bus (utility 2 bus) is shared with wipe edge border fill.
Making a change to one affects the other.
• Even if the wipe border width is set to the same numeric value for main and
sub, the same image is not obtained.
Restrictions on Using Multi Program 2 Mode
• The following functions are not available for sub:
– Data copy and swap
– Default recall (except for parametric recall)
– [AUTO] button function (see page 103)
• Re-entry is limited to five levels. Re-entry is not possible for main and sub
of the same M/E.
However, this restriction can be removed. For details, see “Enabling re-
entry between the main and sub sides of the same M/E bank” (page 489).
• In the following cases, a transition using the fader lever may not be
performed correctly:
– When the main and sub bus toggle modes are set differently
– For a pattern mix, preset color mix, and so on
• For an Internal bus link, GPI link, or External bus link, the “Utility 2” bus
cannot be selected.
• Screen aspect, show key, and [MCRO ATTCH ENBL] button settings are
common to main and sub.
• If a snapshot is recalled simultaneously for main and sub, or a keyframe is
executed simultaneously for main and sub, then for the following common
to main and sub the main settings are reflected.
–Key
–M/E Config
– DME external video bus and utility 1 bus
Snapshots Cross-point
hold
Utility 2 cannot be set Utility 3 is added. BKGD
A/B and Key1 cannot be
set.
Control from an editor Same as standard mode Cannot be used
Operation setting for
switcher GPI inputs and
outputs
Same as standard mode Cannot be used
Item Main Sub