Sony MVS -8000X - Executing a Macro by Macro Attachment

Chapter 16 Macros
958
Macro Attachment Assigning
Executing a Macro by Macro Attachment
Notes
For execution on any of the M/E and PGM/PST banks, use the [MCRO
ATTCH ENBL] button in the cross-point control block. To execute a macro
according to a macro attachment set elsewhere, assign “MCRO ATTCH
ENBL” to a utility/shotbox control block or user preference button, then use
that button.
Executing a macro assigned to a button
1 Depending on the location of the button you want to use, press the [MCRO
ATTCH ENBL] button, turning it on.
2 Press the desired button for which a macro attachment has been set.
This recalls the macro register assigned to the button, and the macro is
executed as follows, according to the operation mode.
Pre macro mode: The macro is executed first, and then the button
function is executed.
Post macro mode: The button function is executed first, and then the
macro is executed.
Macro only mode: The button function is not executed, and the macro
only is executed.
During macro execution, the button you pressed flashes.
Notes
• It is not possible to execute more than one macro at a time. Therefore, even
if you simultaneously press multiple buttons for which macro attachments
are set, only one macro is executed.
• If a button is pressed twice during macro execution or when the macro is
stopped, or if another macro is recalled, the following operation (stop or
continue) depends on a setting in setup.
For details of the settings, see “Setting the Macro Execution Mode” in
Chapter 19 (Volume 3).
Knob Parameter Adjustment Setting values
1 No Macro attachment settings scrolling 1 and upwards