Chapter 14 Snapshots
873
Snapshot Operations in the Menus
When an effect dissolve is set:
When an auto transition is set:
When a GPI output is set:
When a clip event is set:
Setting Key Snapshot Attributes
Applying key snapshot attributes
1
In the Snapshot menu, press VF5 ‘Key Snapshot’ and HF1 ‘Attribute.’
The Snapshot >Key Snapshot >Attribute menu appears.
The status area shows the region names, register numbers, and whether the
registers are locked or not.
D2 Cross-point hold is set for video bus selected for 2nd DME
channel.
FvFkBvBk Cross-point hold is set for all of the DME front video bus, DME
front key bus, DME back video bus, and DME back key bus.
Aux Cross-point hold is set for one of the AUX buses.
Fm1, Fm2 Cross-point hold is set for one of the frame memory 1 and 2
buses.
Ccr1, Ccr2 Cross-point hold is set for one of the CCR 1 and 2 buses.
RTR Cross-point hold is set for the Router region.
Displayed
character codes
Attributes set
Duration value The effect dissolve attribute is set, with the displayed duration.
Displayed
character codes
Attributes set
T Auto transition is set.
Displayed
character codes
Attributes set
Port number GPI output is set for the port of the displayed number.
Displayed
character codes
Attributes set
On Clip event is set.
Displayed
character codes
Attributes set
To Next Page
Loading...
