Safety 11
2005995 Rev O – 210712
Safety
Please follow these simple safety steps to ensure smooth and safe operation:
• While unpacking and setting up the unit, always take care to use proper lifting techniques.
Avoid overreaching and leaning over while handling the printer and accessories.
• While installing, maintaining, and operating the printing system, always wear safety glasses,
gloves, and protective clothing.
• Make sure the electrical power source is properly wired and grounded. The power source
should comply with all safety regulations and codes applicable to the installation location.
• Turn off and unplug the printing system while servicing and performing maintenance.
NOTE: Some service and maintenance procedures require the power to be left on. During
such procedures, carefully follow the safety instructions.
• Use only Squid Ink Manufacturing ink and Squid Ink Manufacturing approved fluids.
• The Squid Ink CoPilot 500 printer systems use a Cartridge Ink or Bag Ink system. Do not
open or puncture the Ink Cartridge or Ink Bag in any way other than normal installation.
• Keep all fluids away from open flame and excessive heat, as they may be combustible.
• Avoid prolonged contact with skin. Fluids can be washed with soap and water.
• Do not look directly into the Printhead. If fluids make eye contact, flush immediately with
water and receive appropriate medical attention.
• Never pour fluids into sink, sewer, or drain. Dispose of fluids in accordance with all
ordinances and regulations pertaining to fluid disposal.
To Next Page
Loading...
