Stratasys Objet1000 Plus - Page 125

Objet1000 Plus User Guide 6 Operating and Maintaining the Objet1000 Plus 3DPrinter
DOC-06810 Rev.B 6-5
Tipsaboutloadingandreplacingmaterialcontainers:
l Youcanloadpartiallyusedcontainers,providedthattheycontainmorethan
100gramsofmaterial.
l Youcanreplacematerialcontainerseitherbeforeorduringprinting.
l Ifprintingstopsforanextendedtimebeforeyoureplaceamaterialcontainer,
theprintermaygointoStandbyorIdlemode.Ifthishappens,see"Resuming
ProductionAfterPrintinghasStopped"onpage6-10.
l Youcanreplaceapartiallyusedcontainertoavoidtheneedforreplacingit
duringprinting.
l Thecontainertypeisautomaticallydetectedbytheprinter.Ifyoureplacea
containerwithonethathasdifferentModelmaterial,amessageappears
recommendingthatyouruntheMaterialReplacementwizardtoflushoutthe
oldmaterial.