Stratasys Objet1000 Plus - Maintaining the Printer; Routine Maintenance Schedule

Objet1000 Plus User Guide 6 Operating and Maintaining the Objet1000 Plus 3DPrinter
DOC-06810 Rev.B 6-22
Maintaining the Printer
Performingroutinemaintenancetasksisessentialforgettingsatisfactory
resultsfromObjet1000Plus3Dprinters.Performthetasksatspecified
intervals.
Routine
Maintenance
Schedule
Frequency Task For More
Information
Beforeprinting CleantheUVlamplenses. 
Before/afterprinting ChecktheUVlampoverheatingindicator. See"UVLamp
Check"on
page6-24.
Before/afterprinting Routinecleaningof:
• printheads
• rollersurface
• wiper
• buildtrayandsurroundingarea
"Cleaningthe
PrintHeads,
Rollerand
Wiper"on
page6-27.
Weekly Cleanthepurgeunitwastecollector. Seestep13of
"Cleaningthe
PrintHeads,
Rollerand
Wiper".
Weekly PerformthePatterntest. See"Pattern
Test"on
page6-24.
Weekly Cleantherollerwastecollector. See"Cleaning
theRoller
WasteCollector
andInspecting
theRoller
Scraper"on
page6-30.
Every300hoursof
printing(Areminder
messageappears.)
CalibratetheUVintensity. See"Testing
andCalibrating
theUVLamps"
onpage6-58.
Every300hoursof
printing
Optimizetheprintheads. See
"Optimizing
(Calibrating)
PrintHeads"on
page6-40.
Every500hoursof
printing
Replacethewiper. See"Cleaning
thePrint
Heads,Roller
andWiper"on
page6-27.