Stratasys Objet1000 Plus - Page 143

Objet1000 Plus User Guide 6 Operating and Maintaining the Objet1000 Plus 3DPrinter
DOC-06810 Rev.B 6-23
Frequency Task For More
Information
Every700hoursof
printing
Replacetherollerpumptubes. See"Replacing
theRoller
WasteTube"
onpage6-61.
Monthly,andafter
replacingprintheads
Checkthealignmentoftheprintheads. See"Aligning
thePrint
Heads"on
page6-36.
Monthly CleandebrisfromtheZ-axisshaftwitha
vacuumcleaner.

Monthly Inspecttheexhaustsystem(duct,fan,
connections).

Monthly Calibratetheloadcells. See
"Calibratingthe
LoadCells"on
page6-64.
Monthly Restarttheprintercomputerandthe
servercomputer.

Everytwoyearsorevery
2500hoursofprinting

Preventivemaintenancevisitbyservice
engineer.
Contactyour
Stratasys
service
provider.
