Stratasys Objet1000 Plus - Calibrating the Load Cells

Objet1000 Plus User Guide 6 Operating and Maintaining the Objet1000 Plus 3DPrinter
DOC-06810 Rev.B 6-64
14.FromtheOptionsmenu,selectMaintenanceCounters.
15.ScrolltoDirt Pumps TubesandclickReset.
Figure6-98Maintenance Countersscreen
Calibrating the
Load Cells
Loadcellsaresensorsthatmeasuretheweightofthematerialcontainersand
thewastecontainerintheprinter.Itisimportantthatyouperiodicallycheck
thattheweightmeasurementsareaccuratetopreventunnecessarywasteof
printingmaterials.Itisrecommendedthatyoucalibratetheloadcellsoncea
month.
Tocalibrateloadcells:
1. StarttheLoadCellCalibrationwizardfromtheOptionsmenu.