Stratasys Objet1000 Plus - Printing Modes 5

Objet1000 Plus User Guide 6 Operating and Maintaining the Objet1000 Plus 3DPrinter
DOC-06810 Rev.B 6-71
ThewizardoperatestheUVlampsandchecksiftheirpoweriswithinthe
acceptablerangeforeachprintingmode.
Note: Themodecurrentlybeingcheckedappearsinthelower-leftcornerof
theprinterinterface.
Figure6-112StatusduringUVlampcheck
AfterreplacingaUVlamp,itisrecommendedthatyoucalibrateitspower.
ThenextscreenallowsyoutocontinuetotheUVCalibrationwizard(see
"TestingandCalibratingtheUVLamps"onpage1).
Figure6-113Finalwizardscreen