Stratasys Objet1000 Plus - UV Radiation; Printer Maintenance; Model and Support Materials

Objet1000 Plus User Guide 2 Safety
DOC-06810 Rev.B 2-6
➢ Neverattempttoopentheservicewindowontherightsideoftheprinter.
Thiswindowshouldalwaysremainlocked,exceptwhentheprinteris
servicedbyauthorizedpersonnel.Donotoperatetheprinterifitisopen.
Figure2-3Servicewindowonrightsideofprinter
➢ Severalpartsoftheprinterremainextremelyhotevenafterithasstopped
operating.AvoidtouchingtheUVlampsandtheprintblock.
UV Radiation
TheUVlampsusedintheprinteremitdangerousradiation.
➢ IftheUVlampsremainonwhentheprinterisopen,donotstaredirectly
attheUVlight.ShutdowntheprinterandcallyourStratasysservice
provider.
Printer
Maintenance
➢ Serviceoperationsshouldbeperformedonlybyqualifiedpersonnelwho
havebeeninstructedinrelevantsafetyprecautions.
➢ Notifyco-workersandthosewhohaveaccesstotheObjet1000Plus
systembeforebeginningnon-routineandhazardouswork.
Reportanypotentialdangersandsafety-relatedaccidentstoyoursafety
officerortootherappropriateauthorities.
Model and
Support
Materials
ModelandSupportmaterialsaremadeofchemicalsubstances.Although
precautionsmustbetakenwhenhandlingthesematerialsdirectly,allModel
andSupportmaterialsusedbytheObjet1000Plussystemarehandledin
sealedcontainers.Normally,operatorsoftheprintershouldneverbedirectly
exposedtohazardousmaterials.Intheunlikelyeventofaleakorspill,follow
theinstructionsthatareincludedwiththeprinting-materialcontainersused.
➢ StoreModelandSupportmaterialsindoors,inadryareawithadequate
ventilation,between15-25degreesCelsius(59-77degreesFahrenheit).
Neverexposethemtoflames,heat,sparks,ordirectsunlight.
➢ KeepModelandSupportmaterialsawayfromareaswherefoodanddrink
arestored,preparedandconsumed.
➢ Uncuredprintingmaterialisconsideredahazardoussubstance,requiring
certainprecautionswhendirectlyhandlingit.Topreventskinirritation,
wearneopreneornitrile gloves.IfthereisanychancethatModeland
Supportmaterialsmightsplashintotheeyes,wearsafetygoggles.
Prolongeddirectcontactwithprintingmaterialscancauseanallergic
reaction.