Stratasys Objet1000 Plus - Printing Indicators

Objet1000 Plus User Guide 6 Operating and Maintaining the Objet1000 Plus 3DPrinter
DOC-06810 Rev.B 6-9
Printing
Indicators
Theprinterinterfacescreenchangeswhenyousendaprintjobtotheprinter,
iftheprinterison line:
•ThemodechangesfromPre-printtoPrinting.
•Thespecificactivitybeingperformedisshowninthe“currentactivity”
field.
•Currentjob-printinginformationisdisplayed.
•Theprintingprogressbarisdisplayed.
•TheStopandPausebuttonsareenabled.
Whentheweightofacontainerdropsbelow100grams,thedisplayofthe
materiallevelintheprinterinterfaceisred.
Figure6-6Printerinterfaceduringprinting