Stratasys Objet1000 Plus - Safety Features

Objet1000 Plus User Guide 2 Safety
DOC-06810 Rev.B 2-2
Safety Features
Objet1000Plus3Dprintersareequippedwiththefollowing
safetyfeatures:
Interlock Switch
ThepowersuppliedtotheUVlampandthemotionmotorsis
turnedoffwhenthedoorsareopened.
Warning
Do not defeat (override) the interlock switch.Doingsocould
resultinseriouspersonalinjury.Iftheinterlockswitchdoesnot
functioncorrectly,donotusetheprinter,andcontactyourservice
provider.
Safety Lock
Thedoorsarelockedwhiletheprinterisworking.Thelockis
releasedwhentheprinterrevertstopauseorstopmode.
Warning
Do not defeat (override) the safety lock.Doingsocouldresult
inseriouspersonalinjury.Ifthesafetylockdoesnotfunction
correctly,donotusetheprinter,andcontactyourserviceprovider.
UV Screening
ThetransparentsectionofthedoorsblocksharmfulUV
radiation,allowingtheoperatortoviewthemodelasitisbeing
made.

Circuit Breaker
Thepowertotheprinteristurnedoffincaseofelectrical
overcurrent.
Note: Thecircuitbreakerisonlyaccessibletoservice
personnel.
UV-Lamp Overheating
Protection
ThepowersuppliedtotheUVlampandthemotionmotorsis
turnedoffifthetemperaturearoundthelampreaches90°C
(194°F).AlabelontheUV-lampcoverindicatesifthe
temperaturehasexceeded65°C(150°F).

Grounded Chassis Thechassisoftheprinterisgrounded,topreventelectrical
shock.
Note:Thepoweroutletmustbeproperlygrounded,in
accordancewiththelocalelectriccode,toprovidethis
protection.