Engine Mechanical: 1D-19
15) Disengage the gearshift link arm by removing the
bolt.
NOTE
Mark the gearshift shaft head at which the
gearshift link arm slit is set for correct
reinstallation.
16) Remove the engine sprocket inner cover by
removing the bolts.
17) Remove the speed sensor rotor (9) while depressing
the rear brake pedal.
18) Remove the engine sprocket nut (10) while
depressing the rear brake pedal.
19) Remove the washer (11).
20) Loosen the rear axle nut (12) and chain adjusters
(13) to provide additional chain slack.
21) Remove the engine sprocket (14).
22) Disconnect the ECT sensor coupler (15), CKP
sensor coupler (16) and generator coupler (17).
I718H1140361-01
9
11
10
I718H1140362-01
12
13
I718H1140363-01
14
I718H1140364-01
15
16
17
I718H1140365-01
To Next Page
Loading...
