Suzuki GSF1250 - Page 272

1D-70 Engine Mechanical:
• Install the gearshift cam stopper plate (5).
NOTE
Align the gearshift cam pin “B” with the
gearshift cam stopper plate hole “C”.
• Apply a small quantity of THREAD ROCK to the
gearshift cam stopper plate bolt and tighten it to the
specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Gearshift cam stopper plate bolt (b): 13 N·m (1.3
kgf-m, 9.5 lb-ft)
• Apply a small quantity of THREAD LOCK to the
gearshift arm stopper (6) and tighten it to the specified
torque.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
Tightening torque
Gearshift arm stopper (c): 19 N·m (1.9 kgf-m, 13.5
lb-ft)
• Install the gearshift shaft assembly (7) and washer (8)
as shown.
NOTE
Pinch the gearshift arm stopper (6) with
return spring ends “D”.
• Install the washer (9) and snap ring (10).
CAUTION
!
Never reuse a snap ring.
5
“B”
“C”
I718H1140245-01
(b)
I718H1140246-03
(c)
6
I718H1140247-02
7
8
“D”
6
I718H1140248-03
9
10
I718H1140249-01