Clutch: 5C-16
9) Install the clutch push piece (9), bearing (10) and
thrust washer (11) to the countershaft.
NOTE
Thrust washer (11) is located between the
pressure plate and bearing (10).
10) Install the spring washer seat (12) and spring washer
(13) onto the clutch sleeve hub correctly.
11) Insert the clutch drive plates and driven plates one
by one into the clutch sleeve hub in the prescribed
order.
NOTE
Insert the outermost No.2 drive plate claws
“A” to the other slits “B” of clutch housing as
shown.
NOTE
For drive plate
Three kinds of the drive plate (No.1, No.2 and
No.3) are equipped in the clutch system, they
can be distinguished by the inside diameter
and clutch facing “D”.
9
10
11
I718H1530050-01
12 13
I718H1530051-01
14. No.2 drive plate
15. No.1 drive plate
16. No.3 drive plate
17. No.1 driven plate (6 – 8 pcs)
: The No.1 and No.2 driven plates are 8 in total.
18. No.2 driven plate (0 – 2 pcs)
: The No.1 and No.2 driven plates are 8 in total.
“C”: Direction of outside
“D”: Clutch facing
: No.1 and No.2 drive plates resemble each other very closely in
external appearance. Make sure to check the numbers of clutch
facing, before installing them.
“B”
“A”
I718H1530052-01
14
16
17 18
17
/
“C”
15
I718H1530053-05
“D”
I718H1530055-01
To Next Page
Loading...
