ROUTER COMMANDS
850
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
router ospf area delete Deletes an OSPF area see page 879
router ospf area ifadd Adds an interface to an area see page 880
router ospf area ifdelete Removes an interface from an area see page 881
router ospf config Set the OSPF daemon configuration settings. see page 882
router ospf debug traceconfig Configures the OSPF daemon tracepoints. see page 883
router ospf flush Flushes the complete OSPF configuration see page 884
router ospf list Lists the OSPF configuration see page 885
router policy accesslist add Creates an empty access list see page 886
router policy accesslist addrule Adds a network prefix towards the specified
access list
see page 887
router policy accesslist delete Deletes an access list see page 888
router policy accesslist deleterule Deletes a network prefix from the specified
access list
see page 889
router policy accesslist flush Removes the complete access list configuration see page 890
router policy accesslist list Displays information about the configured
access lists.
see page 891
router preference Configures the default preferences used per
protocol.
see page 892
router rip config Set the RIP daemon configuration settings. see page 893
router rip debug traceconfig Configures the RIP daemon tracepoint. see page 894
router rip flush Flushes the complete RIP configuration see page 895
router rip ifconfig Configs an interface the RIP daemon will run on see page 896
router rip ifprimauthconfig Specifies the used primary interface
authentication
see page 897
router rip ifsecauthconfig Specifies the used secondary interface
authentication
see page 898
router rip list Show the RIP configuration settings. see page 899
router rip neighbor addtrusted Configures a RIP trusted neighbor see page 900
router rip neighbor addunicast Configures a RIP unicast neighbor see page 901
router rip neighbor deletetrusted Deletes a RIP trusted neighbor see page 902
router rip neighbor deleteunicast Deletes a RIP unicast neighbor see page 903
router rip neighbor list Display the status of the neighboring routers see page 904
router rip policy distlistin Configures a RIP policy to apply to incomming
updates
see page 905
To Next Page
Loading...
Need help?
General
