7. THE PROGRAMMING
There are two programming sections of the VAP416 alarm panel. These are
"Installer Program" <IP> that can be entered by the installer password and "Master
Program" <MP> that can be entered by master code. By using the installer program,
the running type and the properties can be programmed according to the panel
connection. Basic settings are common with the user program. In the user program,
date, time, telephone numbers, user passwords, authorizations etc. and settings
about using of the alarm can be done. In both programming sections, codes and user
settings can be resettled to the factory defaults. The settings about the panel setup,
only can be resettled to the factory defaults by using the installer program.
The programming logic necessitates to enter to concerned address and write to
proper setting. When you enter to an address, the data in the address is showed.
You can enter a new value at this time. The keypad informs the user about the
situation by sound and lights after right or false entries.
Program addresses of VAP416 panel are grouped according to their missions. The
addresses are 4 digit numbers and the first 2 digits indicates the main subject, the
last 2 digits indicates the sub subject.
Main Settings
01-Date/Time
02-Partition Entry Delays
03-Partition Exit Delays
04-CMS Account Numbers
05-CMS Phone Numbers
06-User Phone Numbers
07-User Codes
Panel Settings
10-Panel General Settings
11-Siren Settings
12-Automatic Arm/Disarm
13-PGM Settings
14-Timer Settings
15-Remote Access(by telephone)
16-KEY Settings
Zone Settings
20-Zone Wiring
21-Zone Partition
22-Zon Type
23-Zon Settings
24-Zone Trigger Delay
Keypad Settings
30-Keypad Permissions
31-Keypad Partitions
99-Keypad Inner Settings
User Settings
40-Start time
41-Finish time
42-Authorized days
43-Authorized partitions
44-User Keypads
45-User Limitations
Communicator/Dialer
50-General Settings
51-Reporting Settings
52-53-CMS Event Codes
Optional Modules
60-RF Remote Controller
61-Zone Expander Module
To Next Page
Loading...
