Address 02 01.< IP >
Display for settings:
LED 02 01 (wait)
LCD BASIC SETTINGS→ENTERY DELAYS→01-PART ENT DLY, (wait)
Change for settings:
LED 02 01 <Delay> "√"
LCD BASIC SETTINGS→ENTERY DELAYS→01-PART ENT DLY
<Delay> SECOND "√"
Shown/Entered value: <Delay>, Delay between 0...255 as second
Factory default: 15 second
Example: To set entry delay of A partition to 20 seconds. 02 01 2 0 √
Entry Delay of B Partition
Address 02 02.< IP >
Factory default: 0 second
Entry Delay of C Partition
Address 02 03.< IP >
Factory default: 0 second
Entry Delay of D Partition
Address 02 04.< IP >
Factory default: 0 second
8.1.3. Exit Delays
If any zone at a partition selected as Entry/Exit zone on "Zone Settings", exit delay is
defined hereby with this setting. Follower zone must be in same partition with
Entry/Exit zone. (Look at Zone Settings page 57)
Exit Delay of A Partition
Exit delay is only configured here when SPT is used.
Address 03 01.< IP >
Display for settings:
LED 03 01 (wait)
LCD BASIC SETTINGS→EXIT DELAY→01-PART EXIT DLY (wait)
Change for settings:
LED 03 01 <Delay> "√"
LCD BASIC SETTINGS→EXIT DELAY→01-PART EXIT DLY
<Delay> SECOND "√"
Shown/Entered value: <Delay>, Delay between 0...255 as second
Factory default: 15 second
Example: To set exit delay of A partition to 20 seconds. 03 01 2 0 √
Exit Delay of B Partition
Address 03 02.< IP >
Factory default: 0 second
Exit Delay of C Partition
Address 03 03.< IP >
Factory default: 0 second
Exit Delay of D Partition
Address 03 04.< IP >
Factory default: 0 second
To Next Page
Loading...
